Rewiring Lights Need Electrical Guru

F-Red

F-Red

New member
I've been wanting to clean up my handle bars, by removing the light and kill switch cluster. So I started to tackle it this weekend. I thought I had it figured out, with these drawings, but I must be missing something.

The kill switch is easy, just leave the black/white and green wiring disconnected, using the key switch will be your on/off. As far as the lights, I want the high beam and the on postion to work together, I don't need

the low beam. The switch has an internal light, for on postion, I don't need that option. Any one see a problem with this concept? Thanks for your input. :gr_wink:

04/05 Wiring Diagram

http://www.offtopic.forum/uploads/imported/2013/04/98231A0CF4B249F2B0A06FE597E0434B11630000-1.jpg

The Switch To Be Used

http://www.offtopic.forum/uploads/imported/2013/04/9256382CE3844BB6B5BE9FB7EA49E86F11630000-1.jpg

 
Baileyguns

Baileyguns

Active Members
Stewart, Do you still have that diagram you drew up for me? I'll look for it...

It was a little different from what you're doing Fred, It used a 3 way switch hi/off/low but you could probably figure out how to wire both on and use a 2 way. I'll see if I can find the drawing.

 
OTMTRX

OTMTRX

New member
Here's the drawing I did for Ed mate... not sure if it'll help but may give you some ideas.. ? I'm off work from Wed am onwards so can draw you up something if needed then, I'm not going to get much time before then.

Have a look, see if it helps at all and throw out any questions you have..

Sorry it's a bit rough, it was done for Bailey, he's not as refined as yourself, so please make allowances...:rotflmao:

http://www.offtopic.forum/uploads/imported/2013/04/05TRX450rLightswwiring-1.jpg

Here's the harness I made up using the stock plugs / wires to make it easier to fit etc..

http://www.offtopic.forum/uploads/imported/2013/04/Picture187-1.jpg

And the switch mounted under hood. Toggle left for High, right for low, centre pos is Off.

http://www.offtopic.forum/uploads/imported/2013/04/Picture191-1.jpg

 
Baileyguns

Baileyguns

Active Members
lol, thanks stew! F*ck your diagram I have a horse outside! lmao

Fred, I have a switch with wires already on it if you want it. All youd have to do is splice your wires from the switch to it. Stew sent me a couple when I did my 04.. Then you could do exactly what's pictured above and keep both high and low beams.

 
F-Red

F-Red

New member
Thanks guys for your help. I think I may have found my problem. When I cut the harness off, there were two ground wires going to the cluster. One going to the kill switch, the other one spliced to the ground wire. I believe that splice

feeds the lights, therefore I need to connect these two grounds together. (As Shown) I'll try it tonight. Thanks again guys!

http://www.offtopic.forum/uploads/imported/2013/04/null-1.jpg

Ground shown feeding the lights.

http://www.offtopic.forum/uploads/imported/2013/04/WiringLightsGround1-1.png

 
You must log in or register to reply here.
Top Bottom