Jump to content

Recommended Posts

Posted

http://www.offtopic.forum/uploads/imported/2012/05/trx450rstockcarbvsfcr44-1.png

 

Here is my before and after with the stock 2005 carb jetted right compared to a YFZ FCR straight bored to a 44.

I picked up 2 HP across the board as you can see which actually seems low. I also ran a max speed test up Olds to compare the 2 carbs in the same weekend. Max speed with the stock carb was 49mph and max speed with the 44 FCR was 52 mph!!! I thought that shows how big of a difference the carb can make.

My 2 dyno runs were not done back to back. The fcr was put on a couple of months later when the motor had more time on it so that could be why the difference isn't greater.

 

Motor: +3 hot rods crank unbalanced, CW BB kit, early hrc cam, venom porting, stock size valves in head, Rossier pipe, dyna box, Dasa intake + filter with stock snorkel and air box, 13:1 CP piston, pump gas, tps hooked up, etc.

 

The carb gives the bike better throttle response in the dunes. When racing the hill, the bike pulls much harder throughout the rpm range.

 

This stubborn s.o.b. finally hit 60HP with a very broad curve. I am lovin' this bike now.

Just a little more HP and I should be set.

 

 

  • Replies 10
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted
that is a nice broad curve! why is it so choppy through the curve? i'm used to seeing smoother lines. Might be a noob question, or maybe we are viewing a more detailed graph or something?
05, 13:1 JE, 02 crf cam, full hmf, razr tt tires, rath sway bar, lowering link in the rear, triple rate rebuilds on front.
Posted
that is a nice broad curve! why is it so choppy through the curve? i'm used to seeing smoother lines. Might be a noob question, or maybe we are viewing a more detailed graph or something?

 

Thanks! The broad curve really makes it fun to dune and when draggin' the hill, the power output never really drops between shifts which I feel is a big advantage.

 

Choppy curve: It just seems to be characteristic of this dyno. I have many runs from many different bikes and they are look this way. It could just be as simple as the dyno tires we are using. The run times are much longer on this dyno to simulate the hill which may be causing these spikes to show up. Nothing to be concerned with though.

Just a little more HP and I should be set.

 

 

Posted
ill sell you my piston and jug!! it is 14to1 with your combo!! more hp for ya!! really cheap

 

I think I am good for now. I am going to just enjoy this beast.

Just a little more HP and I should be set.

 

 

Posted

Thanks yfz450~bence. It is a blast to ride.

 

We run on an automotive dyno so the length of the dyno pull is about 6 to 8 seconds. That is what I meant by a longer run time. Atv dynoes only have a run time of about 3 seconds for these bikes due to much lighter rollers.

 

This is a budget build. I only paid $275 for the porting and I think Venom did a great job! He promised me 10% across the board for a power increase and that is exactly what I got. I have dyno runs for this whole build. The dyno runs before and after porting were roughly 50 to 55. 5 HP gain for $275 bucks is a bargain. That is only $55 per HP gain. Where else can you get that?

I think I could go with larger valves, more radical cam, and more aggressive porting to get the top end to not drop off. I think there is enough of a broad curve for me to utilize. This 501 makes so much power down low that it isn't really necessary to rev the snot out of the motor. LOL

Just a little more HP and I should be set.

 

 

Posted

I didnt know it was a car dyno. cool. If thats the gains you saw from porting i wouldnt complain either:gr_nod:

 

Ive seen before and after of good known porters on raptors, and without giant valves and big ccs the gains from porting alone ive seen less than 10%. People really do fall for the poring should give me 20+ % alone. One builder claims 4hp with just a standard valve port, and at 64hp you do the math on the percentage. basically 10% is pretty good IMO

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...